« previous next »
Pages: [1]   Go Down

Author Topic: No able to play from NC  (Read 1931 times)

Offline ranjanpa

  • Full Member
  • ***
  • Posts: 118
    • View Profile
No able to play from NC
« on: October 27, 2014, 08:48:32 AM »
I have a combination of LOR, Dumb RGB and e 682.

NC is not able to play the final fseq file. I can see it in preview but it will not output to light.

I tried with LOR connection removed but still get the error as attached.

Pls advice.

I did shutdown LOR and rebooted my computer too. Still does not output to lights.

[attachment deleted by admin]
Logged

Offline flyinverted

  • Administrator
  • Hero Member
  • *****
  • Posts: 756
    • View Profile
Re: No able to play from NC
« Reply #1 on: October 27, 2014, 05:24:34 PM »
Have you set  your LOR controller to DMX mode via the control pane or dip switches?
Logged
Steve Giron
Maricopa County, AZ
xLights user with a boat-load of channels.

Do not ask to know all the answers, but ask to understand the question.

Offline ranjanpa

  • Full Member
  • ***
  • Posts: 118
    • View Profile
Re: No able to play from NC
« Reply #2 on: October 27, 2014, 07:40:19 PM »
Hi,

I was able to sort this out.

NC expects all the ports to be occupied as per the set up defined. So in my case I had to connect LOR, X Dongle for dumb RGB and Cat 5 for e 632 all together.

Moreover the COM port in which I was attaching the X Dongle was actually COM4. I was assuming this was COM2.

Took a long time to trouble shoot but over it now.

Now I am trying to attach an audio file for the xseq sequence.

Regards.
Logged
Pages: [1]   Go Up
« previous next »