convering to LOR lcb doesn't work

[plasmadrive]

I haven't used this since last year but had no issues then.  I added some pixel trees and programmed those in the models and all works..

I added some more pixels for a jacket and when I convert to a lcb file via "Export", it pastes in nothing. 

My setup in xlights is 4 universes (12-15) for the trees and I have them at 495 channels each. 
My Jacket is set at univ 30 and 129 channels.

My Jacket starts at channel 1981.  It runs out of xlights correctly... but won't get any of that data to LOR.   

Do I have to set those universes at 512?  That should not throw it far enough off so that I get nothing at all in LOR..

any help would be great..  has me at a stop for now..

Thanks,
Craig

[sean]

the files you sent had no rows in the  nutcracker grid.
After you define a model, you must add rows into the grid and then add an effect.
press save,
now youy can export as lcb and there will be data in the file.

[plasmadrive]

Sent you another file... I have tried so many that I must have just grabbed a bad one.. The one I sent you now works fine on xlights but still no export joy

[sean]

i just used your files, i created a lcb from your files.  i loaded up lor. loaded the lcb and pasted , it filled channels everywhere.

maybe we can get on a  teamviewer so i can see what you are doing.

[plasmadrive]

Got it!  I was using "Export" and not "Export Model"

Must be an updated version thing.. I sure don't remember there being anything more than "Export" on my older version. 

I guess I had better keep up..

[sean]

Export has been there from the beginning, export model maybe one year ago. If your model is 100 channels and u had 24000 channels defined in the SETUP tab and u do an export, u will get a 24,000 channel lcb. If u do model export u would get a 100 channel lcb file

[plasmadrive]

My older version was working for me fine last year so I didn't update until middle of this year.. that's why my old version didn't have the Export Model...  So I got messed up by not keeping up..

Thanks again for your time Sean.