Author Topic: outputs/channels all mixed up???  (Read 414 times)

Offline teamflash44

  • Newbie
  • *
  • Posts: 20
    • View Profile
outputs/channels all mixed up???
« on: December 21, 2017, 07:00:49 PM »
I finally got the tree, arches and spiral trees out in the yard after a month of working on it.  This is my first go round and went small to start.  I have been busy wiring, soldering, shrink wrapping, assembling the props, sequencing songs.  I am running a E682 Sansdevice controller with 5v pixles. When I run the E682 self test from the controller's web site everything works correctly.  I plugged everything in while still in my basement and I noticed the first couple of feet of the first arch was not lighting and it was pushing the effect into the next prop.  I was running out of daylight so I took everything outside and set it up.  After I got everything mounted in the yard I only had to wait about 30 minutes for it to be dark enough to see the lights well.  I through my sequences into schedule and let it rip ... waw, waw, waw ... it didn't work.  I shut scheduler off ( It was the first time I even opened scheduler so I figured I didn't set something up) and ran a sequence right from Xlights. Well, it partly worked. The spiral trees are now not working at all (hoping It is a wire pulled apart ... investigate tomorrow), the arch is missing the first 2 feet again and the tree is all mixed up - images are all split up all over the tree and there are sections of the tree not lighting. When I put the controller test back on, the tree and arch light properly.  I'm guessing it is something odd in the set up.  I have 3 strips wired together and then the next controller out put - 1- bottom left to top -tied over to #2 going top to bottom - tied over to #3 going bottom to top.  Strip 4 is on output #2 and repeats.  Seems right ... There are 50 nodes per strip. The star is on output #5 and has 50 nodes.  The arches are tied together and run on output #6.  The arches are 150 led strips cut in half to make 75 each arch.  The spiral trees are the same as the arches and are on output #7.  I am really at a lose and hope someone can look at the set up and tell me what I have wrong.  I'm sure it is something in the set up.  Thank you in advance!

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: outputs/channels all mixed up???
« Reply #1 on: December 21, 2017, 08:47:28 PM »
I think part of the problem is you probably need to define all the universes as size 510.  How else does the E682 know that you only have 450 pixels in universe 1?  etc.