Schedule stop time off by 1 minute

[brichi]

Hey guys, is it normal for a schedule to stop always the minute after you schedule it to end? I know it doesn't just cut the track at lets say 11PM and does a "graceful" ending by letting the track end but every test I have done does the graceful end always starting at 11:01.

For example, I set an end time of 11PM,  a sequence ended at 11:00:30 and the show should now be completely over but it started the next track and then the show ended after that sequence was done at 11:04

Its not a big deal, I can set the show to end at 10:59 but I figured I would report it in case its a bug of being 1 minute off

I also tried a few 10 second sequences and they all played straight through until the clock went to 11:01, then the last one played and ended the show

[jnealand]

Just a wild shot, but is the clock correct on the Pi?  And does it match the clock you are looking at when you test?

[brichi]

nothing is hooked up at all, going by times on bottom of scheduler

[keithsw1111]

The stop time is interpreted as the last minute you want it to run for ... and this is inclusive.


Sent from my iPhone using Tapatalk

[brichi]

The stop time is interpreted as the last minute you want it to run for ... and this is inclusive.


Sent from my iPhone using Tapatalk

thanks Keith, so ill set my off time to 10:59 so they end in the 11:00 minute

[keithsw1111]

The stop time is interpreted as the last minute you want it to run for ... and this is inclusive.


Sent from my iPhone using Tapatalk

thanks Keith, so ill set my off time to 10:59 so they end in the 11:00 minute

That will work.


Sent from my iPhone using Tapatalk