« previous next »
Pages: [1]   Go Down

Author Topic: LOR CCR cabling to DMX  (Read 2136 times)

Offline flyinverted

  • Administrator
  • Hero Member
  • *****
  • Posts: 756
    • View Profile
LOR CCR cabling to DMX
« on: November 16, 2014, 10:46:20 PM »
To get a CCR to work with DMX, cut the end off a Cat 5 cable and wire the other end as follows.


Brown=    Ground
Blue =      DATA +
Blue/Wt = Data -

This is NOT the wiring I'm using for an LOR CMD24, but this is working just fine with a CCR controller connected to a SanDevice E682.   

I hope this helps those trying to sort this one!
« Last Edit: November 16, 2014, 10:47:55 PM by flyinverted »
Logged
Steve Giron
Maricopa County, AZ
xLights user with a boat-load of channels.

Do not ask to know all the answers, but ask to understand the question.

Offline bobbert

  • Newbie
  • *
  • Posts: 30
    • View Profile
Re: LOR CCR cabling to DMX
« Reply #1 on: November 19, 2014, 08:12:36 AM »
What color wire goes in which position?
Logged

Offline flyinverted

  • Administrator
  • Hero Member
  • *****
  • Posts: 756
    • View Profile
Re: LOR CCR cabling to DMX
« Reply #2 on: November 19, 2014, 10:34:03 AM »
It depends on the connector/controller being used

An XLR connector as well as an E682 4 pin Euro connector will be

Brown      Pin 1 Ground
Blue/Wht Pin 2 Data -
Blue         Pin 3 Data +


Don't forget that on the E682, you must configure DMX output via Jumper 22 AND the software config.
All other lighting types are configured via the software config only.
« Last Edit: November 19, 2014, 10:37:08 AM by flyinverted »
Logged
Steve Giron
Maricopa County, AZ
xLights user with a boat-load of channels.

Do not ask to know all the answers, but ask to understand the question.
Pages: [1]   Go Up
« previous next »