I'm just getting started with xLights/Nutcracker and want to move my sequences from LOR to run in xLights to control some new RGB pixel elements. However, as I'm trying to get some initial test lashups done I can only seem to get the pixels to flash or flicker and not hold a steady color. I'm using a Joshua ECG-P2 controller connected to 2 strings in the test setup. In the Test tab, the chase works to light each pixel but it flashes at least twice on each pixel before moving to the next pixel. If I select Background only, I can get all or selected pixels to light but again only as flashing lights. If I go into the Nutcracker tab and add a model of a Star to match my actual display element, it matches but even using ONLY Color Wash in Effect 1 and/or Effect 2 I can get the pixels to light and change color but only as a flashing light. The onscreen display of the Model effect shows a solid image until it changes color as the next timing mark but the actual output is stilling flashing/flickering lights. Am I missing a setting or check box somewhere to get and keep a steady light output? Thanks
