I am using LED icicles not pixels, so I use the Icicle model and tell it the string properties are single color. When my roof line changes angle or goes around a corner I have to start a new model. I use LOR AC controllers to control my LED icicles and I have four different strings so four channels of LOR. So here is the problem; lets say I am building the red icicle models around the roof line I end up with six models because of angle changes, but I assign them all to the same channel on the LOR controller. Problem with that is when I run "Check Sequence" I get warnings of model overlap for all of the icicles. Is there any way to merge the models or tell Xlights that there is a parent model for the channels to prevent these warning?
