Here is the problem, I have 7 controllers hooked up, (lor on dmx) all the lights work flawlessly in test mode, when I hook up controller 8 the controller is showing me that it is getting a signal, but no lights work in test mode, when I play the seq in preveiw using xlights the lights on controller 8 are not firing the commands that have been assigned to them. Trouble shooting, here is what I have tried, I thought a cat 5 issue, so I unhooked the cat 5 that goes from 6 to 7, using that cat 5 I ran that out to 8 still no lights, I removed controller 8 and put up another controller ( yes I changed the unit number to 8 in the hardware utility) still nothing, so then I eliminated controller 6 and went from 5 to 8 still nothing, when I made the change I used the cat 5 that went from 5 to 6 so I know that works. any ideas or anything else I can try? what am I missing?
After talking to Don White here is what else I did, I tried an old lor seq and everything works perfect, so now the question becomes this, if the xseq is corrupt what is the solution? get rid of the xseqs and try converting the lms files again, or do I move the xml files to my desk top uninstall xlights and do a new down load?
