Author Topic: Mapping Lilia's Sequence  (Read 450 times)

Offline buffalobob

  • Jr. Member
  • **
  • Posts: 54
    • View Profile
Mapping Lilia's Sequence
« on: September 20, 2018, 02:35:23 PM »
Hello All

I am mapping a song from Lilia's.

I only have 24800 channels in my setup(48 ports), how do I map the models of her's that have start channels higher than my 25000?

Thanks in Advance
Bob Hlastala
Charlotte, NC

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: Mapping Lilia's Sequence
« Reply #1 on: September 20, 2018, 02:49:49 PM »
You shouldn't even be looking at start channels.  You just select which models from Sequence A you want mapped into Sequence B.

Offline buffalobob

  • Jr. Member
  • **
  • Posts: 54
    • View Profile
Re: Mapping Lilia's Sequence
« Reply #2 on: September 20, 2018, 05:52:45 PM »
I did that and this is what I see when I checked the sequence in xlightsl

    ERR: Model 'Bottom Icicle 1' is not configured for a controller.
    ERR: Model 'Bottom Window Left Matrix' is not configured for a controller.
    ERR: Model 'Bottom Window Right Matrix' is not configured for a controller.
    ERR: Model 'Top Left Icicle' is not configured for a controller.
    ERR: Model 'Top Window Left Matrix' is not configured for a controller.
    ERR: Model 'Top Window Right Matrix' starts on controller '' but ends at channel 26274 which is not on a controller.

What do I need to do
Bob Hlastala
Charlotte, NC

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: Mapping Lilia's Sequence
« Reply #3 on: September 21, 2018, 11:44:19 AM »
Checked what sequence?  You don't need to run check sequence on Lilia's sequence and if you are seeing issues with check sequence like this on your setup then it has nothing to do with imports you just don't have your models defined correctly to point to universes that are on your setup page.