This is my first go at using xlights and x xschedule. I have sequences and models that work in xlights, i have my lor controllers first in setup followed by my dmx channels for my pixel tree and star. The first 144 channels are connected using the lor usb 485b dongle. If i play a sequence in xlights and have the lights on switched on the lor controllers all work as expected and lights cime on. When i go to x schedule my contollers are all green, and i check my schedule for errors and there are none, but when i set up a playlist and then test it with the lights on bulb and schedule enabled, no lights work in the lor controllers . Any ideas on how to figure out the issue. When i check the log of xschedule, it says lor optimised output: sent 0 bytes and also see frame interval greater than 200% of what it should have been[50]
