LOR controllers not working intermittently when sequence is run from Xschedule

[jmhabermn]

I am able to run a sequence directly from XLights and it is able to control my LOR controllers through a LOR network using a LOR dongle.  When I run the sequence from xSchedule the LOR controllers will only work when I start and stop the sequence 3 times.  This the only sequence in this playlist.  I tried deleting the playlist and recreating it.  There are no issues identified in check sequence for both XLights and Xschedule.  Both XLights and Xschedule are using the same show directory.  I am curently running 6 Falcon controllers using ZCPP, 1 LOR network (from dongle) and 1 DMX network (from dongle).

 I'm working to move the LOR and DMX network to the serial output ports on the Falcon controllers but I have an issue with the DMX data being scrambled.  It's doing the same thing on 2 controllers.  I configured the ports using ZCPP.   I'm sending these channels from Xlights but it appears that that the controllers are seeing the following channels:

1 > no output
2 > 1
3 > 2
4 > 3
5 > 4
6 > 5
7 > 6
8 > 13
9 > 14
10 > 15
11 > 10
12 > 11
13 > 12
14 > 7
15 > 8

   Any suggestions?  Thanks

[keithsw1111]

Try .57. There are some serial/zcpp fixes in this release.

When xschedule drops the connection. Do you have logs.

There is no obvious reason why it would work differently to xlights.

[jmhabermn]

The problem with the serial output ports is resolved.  Please note that after I loaded .57 I had to put the controller in E131 mode, change the serial output start address from 2 to 1 and put it back into ZCPP mode to get it to work.  Thanks

[Gilrock]

Version 2019.58 is already out...you're behind.