« previous next »
Pages: [1]   Go Down

Author Topic: Configuration in new version  (Read 766 times)

Offline poporacer

  • Full Member
  • ***
  • Posts: 184
    • View Profile
Configuration in new version
« on: February 22, 2020, 04:52:52 PM »
What would the correct way be to configure the Controller section in the following scenario?
I have a Raspberry Pi that will be connected to an F48 Controller. I will also be outputting video via the HDMI port.
Would you just create one block of Universes or DDP for the FPP instance and the F48 combined? If so, will this upload the E1.31/DDP info to the F48 when it isn't really needed? It isn't a big deal to delete the extra Universes.
Also, technically the IP address for the device outputting the Virtual Matrix data would be the FPP device and not the F48, so should it be set up as different controllers?

Edited- The Matrix would require 109 Universes which I think is beyond the capability of the F48 so would the upload to the F48 fail?
« Last Edit: February 22, 2020, 04:56:34 PM by poporacer »
Logged

Offline keithsw1111

  • Administrator
  • Hero Member
  • *****
  • Posts: 2733
    • View Profile
    • Kellyville Christmas Lights
Re: Configuration in new version
« Reply #1 on: February 22, 2020, 08:12:23 PM »
How would you have done it in the past ..: because essentially you should do it the same way.
Logged

Offline poporacer

  • Full Member
  • ***
  • Posts: 184
    • View Profile
Re: Configuration in new version
« Reply #2 on: February 22, 2020, 10:23:08 PM »
I haven't actually tried it before. After thinking about it, I think you could create a DDP network for the FPP and then an E1.31 Network for the F48.
Thanks for responding and all the work you do!
Logged
Pages: [1]   Go Up
« previous next »