« previous next »
Pages: [1]   Go Down

Author Topic: DMX Flood Channel Presets?  (Read 1049 times)

Offline packetbob

  • Newbie
  • *
  • Posts: 1
    • View Profile
DMX Flood Channel Presets?
« on: February 22, 2020, 10:29:59 PM »
I am very new to xLights so may not be searching for the correct terms...
I have some very cheap 8 channel RGBW floods...
I only want to use the RGB channels (5, 6 & 7)...
I can easily just set these up in the xLights model...
But the lights master output is controlled by channel 1 (regardless of what the RGB channels are set for)
Essentially I always want channel 1 to be set for 255 and then just use the RGB channels for control..
I would think (but could easily be wrong) that I should be able to do this in the Model and then the sequencing could just treat the light as easily as a RGB pixel..

Should I be looking at another way to do it?
Thanks
Logged

Offline Gilrock

  • Supporting Member
  • Hero Member
  • *
  • Posts: 6946
    • View Profile
Re: DMX Flood Channel Presets?
« Reply #1 on: February 24, 2020, 05:53:48 AM »
No we don't automatically activate channels its up to the user to decide when they want channels triggered.  Its pretty easy to put an effect on a lower layer on that model across an entire sequence that triggers the channel.
Logged
Pages: [1]   Go Up
« previous next »