Hi all,
I'm wanting to clean up my Network and Layout settings to make it easier to go on in the future so could use some help for 'current' best practices.
I've attached an image of my current network settings (what xLights condensed everything down to when I upgraded to latest version). Let me know if there are any improvements to the network settings I should be making to make things easier. My first two universes are for my remaining LOR controllers. I don't know if their is a better way to incorporate them into the F48 since they are using 2 separate serial ports on the card.
Then for my layouts, the second screen shot shows my initial LOR controller setup. So I was wondering which way is better (or some other way than I'm doing it). Should I be putting the DMX... with the port and channel on each one, or does just the first one need that DMX setting since all the rest are following the previous channel (or at least that's the way I was planning on setting them up.)
The last screen shot shows a section of the RGB setups (starting at the Universe 6. Is there a better way to set them up other then setting the controller connection values on every one.
So any help or suggestions would be appreciated. I might have more questions as I get into this.