LOR or DMX protocol?

[rickswa]

Hi Everyone,

I think I've got the new controller setup down but just want to verify one thing.  I have 3 LOR boxes left in my layout (numbered 1, 2, and 5) but they have been converted to DMX since I began using xlights.  I use DMX port 3 on a falcon f16v3 to run the data to all three of them.  Right now, with the new layout page, I have them setup as LOR protocol, port 3, and then the respective DMX channel for each model.  Would this be correct or should I actually be setting it as DMX protocol with the rest remaining the same?  Thanks for any help.

[keithsw1111]

They should just be included in your falcon channels. Not a separate line.

[rickswa]

thanks for the reply.  On the controllers page they are listed like that but I was just confused about the layout page as to go about the protocol and port setting

[keithsw1111]

On the layout they should be dmx as that is the protocol they are using.

[djmc2002]

On this same line of questions, I have one LOR controller left that is running off a san device bridge (which outputs DMX to my LOR. How do I list the bridge on the set up page? or can I just move that physical connection to my Falcon? I was using the bridge for both LOR and my dmx (my 27 channel light controlers) but I moved the dmx connnection onto my Falcon but at present still have the LOR stuff hooked up to the bridge.  -- Thanks did not want to hijack the OP but along the same line of questions

[keithsw1111]

As an e131. Xlights only cares about the device it is talking to.