Mega Tree - Programatically Move/Rotate Center

[marksat]

Ok - I put up the megatree, but the center/start point is not where I meant to put it (e.g. string 1 should be pointing due South, but is off a bit).

Is there a way to adjust the model output in XLights (instead of physically re-positioning the strands of the tree, or adjusting every sequence)?

I tried adjusting the RotateY attribute on the Layout tab, Size/Location area but that does not seem to do anything.

Thank you in advance.

[Bill - PVL]

I have this same question.   I would like to turn it about 25 degrees and can't figure out a way to do it.  Did you get an answer?

[K-State Fan]

Set the rotation to what you want it to be on the model setup