How can I use my Falcon F16V3 to run a sequence without having to use internet?

[SNIPESCASTLE2]

Good morning everyone!(or evening depending on where you are located)
My Church is decorating a float for our town Christmas Parade, and they asked if
I can run some Pixels on the float. I?ve been running my shows through my internet and router
at home.

I vaguely remember being able to use my Falcon through my laptop to run a few props,
But for the life of me I cannot find the instructions of how I did that.
Can anyone give me the steps of how I can bypass using internet and just use my laptop
directly to my controller?

Thank you!
Ben Smith
(816)956-1202

[allknowing2012]

Dont need the internet at all .. but you will have to configure your laptop ethernet port to point to the same subnet as your falcon. So if you falcon is 192.168.1.50, you configure your laptop eth0 to 192.168.1.100 say
Do this via network config within windows.