Falcon Controller F16v3 is having an issue

[Chris_F]

So my f16v3 is having an issue. it keeps rebooting. i read somewhere to hold down the setup button and power on the controller to reset it so i did this and it works for a few then it crashes again. it will play a sequence for a minute then it freezes. when i try to access it via browser its offline or its red in xscheduler. i checked my power supply and its reading 12.05 volts. has anyone had this issue or or does anyone have any ideas to try? any help would be greatly appreciated.

[K-State Fan]

I have not had any problems with mine but I would do a factory rest first if mine was having the problem.

This process is used to reset all settings set by the user on the controller.  This does not reset the firmware.

Perform the following steps:

Power off your controller and wait at least 20 seconds before proceeding.
Hold down the ?Select? button.  Keep holding it down while applying  power to the controller.
Keep holding down the ?Select Button? until you see Status LED1 and LED2 rapidly blink together and the OLED Display will display ?Resetting Controller?
Release the ?Select Button?, the controller will reboot with the default settings.