Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Todd

Pages: [1]
1
Do You Need Help? Post it here / Re: Audio waveform gets out of sync
« on: December 04, 2020, 04:16:57 PM »
That seems surprising as one of the first things xlights does when the audio loads is convert it to fixed rate pcm data.
I know from experience. I had a sequence a while back doing the same thing and it was variable bit rate. Re did it in fixed and all was fine.


Sent from my iPhone using Tapatalk

2
Do You Need Help? Post it here / Re: Audio waveform gets out of sync
« on: November 30, 2020, 12:43:33 PM »
Is your music variable bit rate or fixes but rate?


Sent from my iPhone using Tapatalk

3
Or vixen


Sent from my iPhone using Tapatalk

4
Post your screen shots if you setup in XLights and the Falcon f16 e131page and string port pages


Sent from my iPhone using Tapatalk

5
Falcon Pi Player / Lost show folder
« on: December 15, 2019, 11:22:59 AM »
Is the HD totally toast or could you get into the HD outside of the computer. I have an external drive I can put a HD into and sometimes are able to find things on it. But more importantly......back up!


Sent from my iPhone using Tapatalk

6
Enhancement Requests / Re: New Feature Request
« on: March 06, 2018, 03:43:17 PM »
I would like to see the first suggestion also. It was a feature I always liked it when using LOR and you could have two or more sequences open at one time.


Sent from my iPad using Tapatalk

7
General hardware / Re: Acceptable quality/price?
« on: March 01, 2018, 03:04:29 AM »
Use some of them also. Out of 1,600 I had three fail on the blue. Pretty acceptable failure rate


Sent from my iPhone using Tapatalk

8
Do You Need Help? Post it here / Re: LOR and setup question
« on: February 27, 2018, 04:10:02 AM »
Make sure you have the correct firmware on the LOR controllers or they will not work in DMX mode


Sent from my iPhone using Tapatalk

9
Nutcracker Effects / Re: How to make a lid effect on my mini trees?
« on: February 25, 2018, 07:48:36 PM »
I think this is the effect you're looking for to get a ring of lights to go up or down a mega tree ( I use this for my mega tree), should work for mini trees also.....try this....Single stand effect. Group all arches. Left to right to go up or right to left to go down. Set chases, chase size and cycles to suit your needs.


Sent from my iPad using Tapatalk

Pages: [1]