I ran into some strange problems with xlights 4.2.18 yesterday and had to revert back to creating a sequence in xlights 3. While my overall setup is rather complex, here is the jist of what I was trying to do. I'm sure the reason I'm having a problem is I'm still new with xlights 4 for sequencing and don't fully understand the logic.
My setup is Pi (I have a master and two BBB remotes that have p10 panels on them) to FPD to a F16hub (pixel net in/out) to a DLA active hub (pixelnet in, dmx out) to a Ray 27 controller to a DLA lynx express to a Chauvet 1800 fogger.
In xlights 3 I have always done a color wash red to fire my fogger in the past and last night had to create a xseq to do the same thing because for some reason I couldn't figure out why my xlights 4 sequence wasn't working.
I have attached a couple of sequences. One for twightlite zone where the fogger works with my colorwash effect and one called spooky-fog where the fogger does not work.
Can anyone tell by simply looking at the sequences what the heck I was doing wrong? I've also included the rgbeffects and networks xml files. If I need to post up anything else let me know.
thanx!
Ryan