Folks, I need a Plan B here.
I had many issues running LOR stuff from my PixLite 16 controllers. Well, discovered it was ALL the DMX512 ports not working!
So, now I need an alternative to run my CCR's(3), 8RGB floods with CMB24D, and (2) LOR PC16 controllers.
Since I have everything setup to run my LOR in DMX, do I have to change anything in the setup tab in XL/NC?
How will I connect my LOR USB 485 dongle to control the lights in XL/NC?
If I set it up as a LOR then don't I only have 96 channels? The CCR's are 450 channels. This is why I chose to go DMX mode.
Right now I have on Universe 1 510 channels set for the LOR stuff, with appropriate DMX Starting addresses.
Universe 2 is for running my CCR's .
I have a FPP, understand it will do LOR now, would I just insert the LOR 485 into the FPP, then use the other screen in FPP to select the universe for the LOR stuff? Could it be that easy? Nothing has been easy so far, so I doubt it.
Bottom line, I need some step by step assistance if possible. Many Thanks.
Best,
David