Hi, hope advice is available. ( Apologies if this has been resolved previously )
Some of my models do not light up as displayed in the xlights sequencer window.
As an example
6 mini trees should light up at once as shown in xlights house preview displaying the models,
but instead, 3 mini trees and 3 other models light up.
I have checked channel mapping and it seems ok. I have also done a Check Sequence.
the only problems found were " fill sequence without a position value curve " which i suspect is not the problem here.
have recently updated to latest version of xlights. ( including backups )
Note : this does not happen over the whole length of the sequence. models do perform as per the sequence in some sections of the sequence.
Every time i reopen the sequence, the model faults react in the same way.